3. Turn the scanner glass-side up and use a small flat-blade screwdriver to carefully remove ten
adhesive screw caps (callout 2) Remove the ten screws that are exposed when the caps are
removed.
NOTE Do not damage the caps when you remove them. Do not excessively handle the
adhesive side of the caps. Skin oils will damage the adhesive on the back of the caps.
2
Figure 5-90 Remove the scanner glass assembly and top cover (2 of 7)
4. Use a small flat-blade screwdriver to release the remaining eight tabs (callout 4) around the outside
edge of the scanner top cover.
Tip Release the outside edge top cover tabs by starting near the right hand corner of the
scanner opening and working in a clockwise direction around the cover, and then releasing
the inner tab.
Figure 5-91 Remove the scanner glass assembly and top cover (4 of 7)
236 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...