Upper cassette pickup assembly
1. Remove the following components or assemblies:
●
ADF. See
ADF assembly on page 204.
●
Scanner. See
Scanner assembly on page 232.
●
Stapler/stacker. See
Stapler/stacker assembly on page 254.
●
Base unit formatter cover. See
Formatter cover on page 290.
●
Base unit rear cover. See
Rear cover on page 295.
●
Base unit face-down cover. See
Face-down cover on page 291.
●
Base unit top cover. See
Top cover on page 312.
●
Base unit front cover. See
Front cover on page 296.
●
Base unit left rear cover. See
Left rear cover on page 311.
●
Base unit right rear cover. See
Right rear cover on page 315.
●
Base unit right rear inner cover. See
Right rear inner cover on page 313.
●
Base unit right door. See
Right door on page 306.
●
Interconnect PCA assembly. See
Interconnect PCA assembly on page 345.
●
Lower cassette drive assembly. See
Lower cassette drive assembly on page 362.
●
Print cartridge door. See
Print cartridge door on page 318.
2. Disconnect one connector (callout 1) and release the wire harness from the retainer (callout 2).
Remove the retainer clip from the shaft and slide the upper cassette pickup assembly clutch
(callout 3) off of the shaft and set it aside.
3
2
Figure 5-277 Remove the upper cassette pickup assembly (1 of 3)
ENWW Print engine (base unit) 359
To Next Page
Loading...