Main motor
1. Remove the following components or assemblies:
●
ADF. See
ADF assembly on page 204.
●
Scanner. See
Scanner assembly on page 232.
●
Stapler/stacker. See
Stapler/stacker assembly on page 254.
●
Formatter cover and cage. See
Formatter cover and cage on page 199.
●
Base unit rear cover. See
Rear cover on page 295.
●
Base unit top cover. See
Top cover on page 312.
●
Base unit right rear cover. See
Right rear cover on page 315.
●
Base unit right rear inner cover. See
Right rear inner cover on page 313.
●
Interconnect PCA assembly. See
Interconnect PCA assembly on page 345.
●
Low-voltage power supply. See
Low-voltage power supply assembly on page 342.
●
DC controller PCA. See
DC controller PCA on page 357.
●
Lower cassette drive assembly. See
Lower cassette drive assembly on page 362.
2. Before you begin this procedure, note the routing of the wire harness as shown in
Figure 5-282
Remove the main motor (1 of 7) on page 363.
Tip Reinstall wire harnesses originating from the lifter drive assembly area of the device
into the retainer closest to the main drive assembly. Reinstall wire harnesses from the pickup
assembly solenoid area into the retainer closest to the lower drive gear assembly.
Figure 5-282 Remove the main motor (1 of 7)
ENWW Print engine (base unit) 363
To Next Page
Loading...