Lower cassette pickup assembly
1. Remove the following components or assemblies:
●
ADF. See
ADF assembly on page 204.
●
Scanner. See
Scanner assembly on page 232.
●
Stapler/stacker. See
Stapler/stacker assembly on page 254.
●
Formatter cover and cage. See
Formatter cover and cage on page 199.
●
Base unit rear cover. See
Rear cover on page 295.
●
Base unit front cover. See
Front cover on page 296
●
Base unit top cover. See
Top cover on page 312.
●
Base unit right rear cover. See
Right rear cover on page 315.
●
Base unit right rear inner cover. See
Right rear inner cover on page 313.
●
Interconnect PCA assembly. See
Interconnect PCA assembly on page 345.
●
Low-voltage power supply. See
Low-voltage power supply assembly on page 342.
●
Lower cassette drive assembly. See
Lower cassette drive assembly on page 362.
2. Remove the retainer ring on the shaft and carefully pull the lower cassette pickup assembly clutch
(callout 1) off of the shaft and set it aside.
Figure 5-291 Remove the lower cassette pickup assembly (1 of 5)
368 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...