Lifter driver assembly
1. Remove the HCI back cover. See Back cover on page 376.
2. Disconnect two connectors (callout 1).
1
Figure 5-318 Remove the HCI lifter driver assembly (1 of 2)
3. Remove three screws (callout 2) and release one tab (callout 3). Remove the HCI lifter drive
assembly (callout 4).
4
3
2
Figure 5-319 Remove the HCI lifter driver assembly (2 of 2)
4. Repeat this procedure for the remaining HCI lifter drive assemblies.
384 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...