Clear jams
When clearing jams, be very careful not to tear the media. If a small piece of media remains in the device,
it could cause additional jams.
Clear jams from the automatic document feeder (ADF)
Occasionally, media becomes jammed during a fax, copy, or scan job. When this happens, the control-
panel message Jam in document feeder alerts you to the jam. To clear the jam, follow the instructions
on the onscreen dialog box or follow the steps below.
1. Open the ADF cover.
2. If you were copying two-sided documents, lift the green lever to open the reversing unit, and then
remove any media from inside the reversing unit.
3. Gently try to remove the page without tearing it. Also pull paper from the ADF output bin. If you feel
resistance, go to the next step.
ENWW Clear jams 459
To Next Page
Loading...