17. Remove six screws (callout 1), and then remove the main drive assembly (callout 2).
NOTE: Make sure that the right door is closed.
Figure 2-101 Remove the main drive assembly (17 of 17)
2
1
Install the main drive assembly
NOTE: Installing a replacement assembly: follow the instructions in this section.
Reinstalling the original assembly: some of these instructions in this section do not apply (for example,
removing the shipping spacers). Do not rotate the gears when handling the assembly. If the gears are rotated
—and become out of phase—it will be difficult to install the assembly on the product.
1. Do not remove the orange spacers and spacer shipping tape (callout 1) installed on the replacement
main drive assembly. Remove the remaining shipping tape (callout 2).
CAUTION: A gear (callout 3) on the back of the assembly is not captive when the shipping tape is
removed. Do not lose the gear when handling the assembly with the shipping tape removed.
When removing tape, make sure that the entire strip is removed. Check the back of the assembly to
verify that the entire strip of tape is removed.
ENWW Removal and replacement procedures 159
To Next Page
Loading...