1. Press the Home button .
2. Press the Down arrow
to highlight the Device Maintenance menu, and then press the OK button.
3. Press the Down arrow
to highlight the Calibration/Cleaning menu, and then press the OK button.
4. Press the Down arrow
to highlight the Full Calibration or Quick Calibration setting, and then press the
OK button.
●
Full Calibration: takes about 70 seconds and performs color plane registration, environment
change control, and Dmax and Dhalf adjustments. Use Full Calibration if colors are misaligned or
appear blurry. Full Calibration runs automatically after a replacement transfer belt (ITB) is
installed. Full Calibration must be run manually after a laser scanner is replaced.
●
Quick Calibration: takes about 45 seconds and performs Dmax and Dhalf adjustments. Use Quick
Calibration if colors are wrong, highlights are missing, or if colors are too dark or too light.
ENWW Tools for troubleshooting 345
To Next Page
Loading...