HP M750 series

Table 3-29 General Settings menu (continued)
First level Second level Third level Fourth level Values Description
Transfer Control Normal*
Alternate 1
Alternate 2
Alternate 3
Corrects transfer
issues in print jobs.
Turn this feature on if
green, mottled images
are printed on the
page. Note that using
this mode can
increase problems
with blurry images or
specks of toner on the
leading or trailing
edge of the paper. The
Alternate 1 setting
reduces the T1 bias
and should be used
when re-transfer
occurs. The Alternate
2 setting increases the
inter-page gap. Using
this setting reduces
throughput and might
decrease the print-
cartridge life. The
Alternate 3 setting
applies the Alternate 1
setting and the
Alternate 2 setting at
the same time. Use
this setting if the first
two settings do not
correct the problem.
Fuser Temp Normal*
Alternate
If you are seeing a
faint image of the
page repeated at the
bottom of the page or
on the following page,
you should first make
sure the Adjust Paper
Types setting and the
Print Mode setting are
correct for the type of
paper you are using. If
you continue to see
ghost images on your
print jobs, set the
Fuser Temp feature to
the Alternate setting.
Restore Optimize Returns all the
settings in the
Optimize menu to the
factory-default
values.
Resolution Image Ret 3600
1200 x 1200dpi
Sets the resolution at
which the product
prints.
ENWW Tools for troubleshooting 357