Table 3-36 Jetdirect Menu (continued)
First level Second level Third level Fourth level Values Description
Link Speed Auto* The link speed and
communication mode
of the print server
must match the
network. The
available settings
depend on the
product and installed
print server.
CAUTION: If you
change the link
setting, network
communications with
the print server and
network product
might be lost.
The print server uses
auto-negotiation to
configure itself with
the highest link speed
and communication
mode allowed. If
auto-negotiation fails,
either the 100TX Half
feature or the 10T
Half feature is set
depending on the
detected link speed of
the hub/switch port.
(A 1000T half-duplex
selection is not
supported.)
10T Half 10 Mbps, half-duplex
operation.
10T Full 10 Mbps, full-duplex
operation.
10T Auto 10 Mbps, half-duplex
operation.
100TX Half 100 Mbps, half-duplex
operation.
100TX Full Limits auto-
negotiation to a
maximum link speed
of 100 Mbps, full-
duplex operation..
100TX Auto 100 Mbps, full-duplex
operation.
Troubleshooting menu
To display: At the product control panel, select the Administration menu, and then select the
Troubleshooting menu.
ENWW Tools for troubleshooting 381
To Next Page
Loading...