HP M750 series

NOTE: If this message appears after the lifter drive assembly was removed or replaced, make sure that the
connector on the assembly is correctly connected and fully seated.
If the error persists, use the Media size switches (SW2,3 - SW82,83 - SW92,93) test in the Tray/Bin manual
sensor test to test the switches.
If they do not respond, replace the associated the lifter drive assembly.
Tray <X> overfilled
Description
The tray is filled above the stack-height mark.
●
X = 2
Tray 2
●
X = 3
Tray 3
●
X = 4
Tray 4
●
X = 5
Tray 5
●
X = 6
Tray 6
Recommended action
Remove enough paper so that the paper stack does not exceed the limit for the tray.
NOTE: If this message displays after lifter drive assembly was removed or replaced, make sure that the
connector on the assembly is correctly connected and fully seated.
Troubleshooting
Description
The product is in the troubleshooting process.
Recommended action
Press the Stop
button .
To exit press X
Type mismatch Tray <X>
Description
The specified tray contains a paper type that does not match the configured type.
484 Chapter 3 Solve problems ENWW