HP M750 series

Table 3-61 Preboot menu options (4 of 5)
Menu option First level Second level Third level Description
Administrator
Tools
continued
Configure LAN
Network Setup
IP Mode [ ]
Select the Configure LAN item to setup the network settings
for the PreBoot menu firmware upgrade.
The network can be configured obtain the network settings
from a DHCP server or as static.
[DHCP] Use this item for automatic IP address acquisition from the
DHCP server.
[Static] Use this item to manually assign the network addresses.
IP Address Use this item to manually enter the IP addresses.
Subnet Mask Use this item to manually enter the subnet mask.
Default
Gateway
Use this item to manually enter the default gateway.
Save and Exit Select the Save and Exit item to save the manual settings.
Table 3-62 Preboot menu options (5 of 5)
Menu option First level Second level Third level Description
Administrator
Tools
continued
Startup
Options
Select the Startup Options item to specify options that can
be set for the next time the product is turned on and
initializes to the Ready state.
Show Revision Not currently functional: Check the Show Revision item to
allow the product to initialize and show the firmware
version when the device reaches the Ready state.
When the product power is turned on the next time, the
Show Revision item is unchecked so the firmware revision is
not shown.
Cold Reset Check the Cold Reset item to clear the IP address and all
customer settings (this item also returns all settings to
factory defaults).
NOTE: Items in the Service menu are not reset.
Skip Disk Load This item allows the device to be started without loading
the third party applications.
This means that files including Accessible Architecture on
the disk will not be available at bootup. This is useful for
troubleshooting problems with the hard disk without having
to remove the hard disk. It also applies to flash file system
disks on DIMMs.
In this case, this function will cause the printer to configure
the HP firmware first, followed by the third-party
applications.
NOTE: The files on the disk will be available after the
printer enters the Ready state.
Skip Cal Select the Skip Cal item to initialize the product the next
time the power is turned on without calibrating.
532 Chapter 3 Solve problems ENWW