4. Grasp the tab on the hard drive cable connector (3), and then carefully press the hard drive
cable connector onto the system board until it snaps into place.
5. Replace the vanity cover (refer to Replacing the vanity cover on page 26).
6. Replace the battery (refer to
Inserting the battery on page 24).
7. Reconnect external power and external devices.
8. Turn on the computer.
Replacing the memory module
The computer has one memory module slot. The capacity of the computer can be upgraded by
replacing the existing memory module in the memory module slot.
WARNING! To reduce the risk of electric shock and damage to the equipment, unplug the power
cord and remove all batteries before installing a memory module.
CAUTION: Electrostatic discharge (ESD) can damage electronic components. Before beginning
any procedure, ensure that you are discharged of static electricity by touching a grounded metal
object.
To replace the memory module:
1. Remove the battery (refer to
Removing the battery on page 25).
2. Remove the vanity cover (refer to
Removing the vanity cover on page 26).
3. Remove the existing memory module:
a. Pull away the retention clips (1) on each side of the memory module.
The memory module tilts up.
Replacing the memory module 29
To Next Page
Loading...
