HP Mini 210-1040 Maintenance And Service Guide

105 pages

To Next Page

To Previous Page

6. Release the ZIF connector (2) to which the TouchPad cable is connected, and then disconnect

the TouchPad cable (3) from the system board.

7. Remove the five Phillips PM2.0×6.0 screws that secure the top cover to the base enclosure.

8. Release the top cover (1) by lifting the rear edge until it disengages from the base enclosure.

Component replacement procedures 53

Other manuals for HP Mini 210-1040

Need help?

Do you have a question about the HP Mini 210-1040 and is the answer not in the manual?

General