Removal and replacement procedures 32
4. Remove the large redundant fan air baffle.
To replace the component, reverse the removal procedure.
DIMM baffle
To remove the component:
1. Power down the server (on page 26).
2. Do one of the following:
o Open or remove the tower bezel, as needed ("Front bezel" on page 28).
o Extend the server from the rack (on page 25).
3. Remove the access panel ("Access panel" on page 29).
4. Remove the large redundant fan air baffle, if installed ("Large redundant fan air baffle" on page
31).
To Next Page
Loading...
