hp officejet 4100 series
chapter 3
8
2 Slide the right and left paper guides in until they stop at the edges of the
paper.
load paper
Following is the basic procedure for loading paper. There are specific
considerations for loading certain types of paper, transparency film, postcards,
and envelopes. After you review this procedure, see tips for loading other types
of paper in the paper tray on page 13, load 4 x 6 inch photo paper on
page 10, load envelopes on page 10, and load postcards or hagaki cards on
page 11.
For best results, adjust the paper settings each time you change paper types or
paper sizes. For more information, see set the paper type on page 15.
to load the paper tray
1 Lower the paper tray, and extend the paper-tray extender.
2 Slide the paper-width guide to its outermost position.
3 Tap the stack on a flat surface to align the edges of the paper, and then
check the paper for the following:
– Make sure it is free of rips, dust, wrinkles, and curled or bent edges.
– Make sure all the paper in the stack is the same size and type, unless
you are working with photo paper.
4 Insert paper into the paper tray print-side down until it stops. If you are
using letterhead, insert the top of the page first.
Be careful not to use too much or too little paper. Check that the stack of
paper contains several sheets but is no higher than the top of the paper-
width guide.
To Next Page
Loading...