5. Clean the plastic strip with a soft cloth or sponge slightly moistened with a
nonabrasive glass cleaner.
CAUTION: Do not use abrasives, acetone, benzene, or carbon tetrachloride
on the plastic strip, since they can damage it. Do not place or spray liquid
directly on the plastic strip. The liquid might seep under the glass and damage
the device.
6. Gently lower the automatic document feeder mechanism to avoid dislodging the
plastic strip, and then close the cover of the automatic document feeder.
7. Plug in the power cord, and then turn on the device.
NOTE: If you still see dust or lines on scans after cleaning the plastic strip, you
may need to order a new plastic strip. For more information, see
Solve a
problem.
Turn off the device
Turn off the product by pressing the (power) button located on the product. Wait
until the power light turns off before unplugging the power cord or turning off a power
strip. If you improperly turn off the product, the print carriage might not return to the
correct position causing problems with the ink cartridges and print quality issues.
Chapter 1
24 Get started
To Next Page
Loading...