redial and no-answer-redial options. Use the following procedure to turn the options on
or off.
• Busy redial: If this option is turned on, the device redials automatically if it receives
a busy signal. The factory-set default for this option is ON.
• No answer redial: If this option is turned on, the device redials automatically if the
receiving fax machine does not answer. The factory-set default for this option is
OFF.
To set the redial options
1. Press Setup.
2. Press right arrow
to select Fax Settings, and then press OK.
3. Press right arrow
to select Redial Options, and then press OK.
4. Press right arrow
to select the appropriate Busy Redial or No Answer Redial
options, and then press OK.
Set the fax speed
You can set the fax speed used to communicate between your device and other fax
machines when sending and receiving faxes.
If you use one of the following, setting the fax speed to a slower speed might be
required:
• An Internet phone service
• A PBX system
• Fax over Internet Protocol (FoIP)
• An integrated services digital network (ISDN) service
If you experience problems sending and receiving faxes, try using a lower Fax Speed.
The following table provides the available fax speed settings.
Fax speed setting Fax speed
Fast v.34 (33600 baud)
Medium v.17 (14400 baud)
Slow v.29 (9600 baud)
To set the fax speed from the device control panel
1. Press Setup.
2. Press right arrow
to select Fax Settings, and then press OK.
3. Press right arrow
to select Fax Speed, and then press OK.
4. Select an option using the arrow keys, and then press OK.
Change fax settings 55
To Next Page
Loading...