Setup and Configure hp confidential 55
2 Preparing the
location
1. Ensure that the surface where you
place the all-in-one is sturdy, flat,
and located in a well-ventilated
area.
2. Leave space around the all-in-one,
including 50 mm (2 inches) for
ventilation. Leave enough room
behind the all-in-one to open the
flatbed scanner lid.
3. Do not allow direct sunlight on the
all-in-one.
4. Avoid presence of any chemicals
near the all-in-one.
5. Temperature requirements: 15 to 35
degree Celsius (C) (59 to 95 degree
Fahrenheit [F]).
6. Humidity requirements: 15 percent to
80 percent non-condensing.
7. Power requirements: 110 to 240 volts
AC, 50/60 hertz (Hz) (+-3 Hz).
3 Unpacking the
printer and its
components
1. Remove the packing tape from
around the paper tray and the
control panel.
2. Open the flatbed scanner lid and
remove the packing tape and
material from the scanner glass
area.
3. Close the flatbed scanner lid and
remove the packing tape from the
Automatic Document Feeder (ADF)
area and the ADF output tray.
4. Open the print-carriage access door
by lifting the print-carriage access
handle and unlock the scanner.
5. Unpack Tray 2 and remove the
packing tape and shipping
material. (Tray 2 is available with
9120 and 9130).
6. Place Tray 2 on the prepared
location, and then place the all-in-
one on the tray.
To Next Page
Loading...