56 hp
confidential Setup and Configure
4 Replacing the
control-panel
overlay with the
preferred Language
1. Make sure that the power is off and
the power cable is unplugged
before performing this step. If
necessary, replace the existing
control-
panel overlay (control panel
cover) with the overlay of the
language of your choice (available
for selected countries only).
2. Use a flathead screwdriver to loosen
the control panel cover.
3. Lift it off the control panel.
4. Align the new control panel cover
with the control panel buttons.
Insert the top portion first, and then
press down on the bottom to snap
the overlay into place.
5 Installing the auto-
duplex unit
Slide the auto-duplex unit into the all-in-
until it locks into place.
6 Installing the ADF
input tray
1. Align the tabs on the ADF input tray
with the slots on the ADF.
2. Slide the ADF input tray into the slots
until it snaps into place.
7 Installing the
keyboard (The
keyboard comes
installed with 9130)
1. Open the print-carriage access door
by lifting the door handle.
2. The keyboard tray lock is situated
under the print-carriage access
door. Remove the keyboard tray
lock and then close the door.
3. Press and release the keyboard tray
to open the tray.
4. If there is a cover over the keyboard
tray, remove it by pressing the two
release latches under the tray.
5. In
sert the back edge of the keyboard
into the tray, and then press the
keyboard down until it snaps into
place.
To Next Page
Loading...