Setup and Configure hp confidential 57
8
1. To load paper into a tray, pull the
tray out. When loading paper into
Tray 1, raise and remove the output
tray.
2. If the is paper between 279 mm and
356 mm (11 inches and 14 inches)
long, slide the latch on the tray
edge in front of the tray to the right
and lower the front of the tray. The
tray need not be lowered when
loading A4-size, letter-size, or smaller
media.
3. Place the media in the tray with the
print side down and then slide the
media length and width adjusters to
the edges of the media. The paper
capacity of Tray 1 is 150 sheets and
Tray 2 is 250 sheets.
4. Reattach and close the output tray
after loading Tray 1.
5. Slide the tray back into the all-in-one.
6. Pull out the extension on the output
tray to support the printed media.
9 Connecting the
power cord and
turning on the all-in
one
1. Connect the power cord to the all-
in-one and an AC power outlet.
2. Press the
(Power)
button on the
control panel to turn on the all-in-
one.
10 Setting the
language,
country/region,
date, and time
1. After turning the power on for the
first time, the control panel prompts
the user to set the language.
2. At the prompt, use the (
up
and
down
) buttons on the control panel
to move to the desired language,
and then press the
(select)
button.
3. The control panel prompts the user
to set the country/region.
4. Press the
-
or
+
buttons to select the
desired country/region, and then
press the
(select)
button.
5. Next, the control panel prompts the
user to set the time.
6. To set the date, use the keypad or
the keyboard to type the date and
then press the
(select)
button.
7. Type the time and then press the
(select)
button.
To Next Page
Loading...