HP Officejet 9100 Series - Page 64

58 hp confidential Setup and Configure
11 Installing the ink
cartridges
1. Remove each ink cartridge from its
package.
2. Open the print-carriage access door
to gain access to the printing
supplies area.
3. Align the colored arrows and insert
each ink cartridge into its respective
color-coded socket.
4. Press in each ink cartridge to ensure
proper contact.
12 Installing the
printheads
1. Turn on the all-in-one.
2. Open the print-
carriage access door.
Remove the packing tape from the
printhead latch under the door.
3. Lift the printhead latch forward and
down to release the hook from the
metal latch.
4. Lift and push the latch toward the
rear of the all-in-one.
5. Remove foam package from the
printhead slot.
6. Remove each printhead from its
package, and then remove the
nozzle protective tape from each
printhead.
7. Insert each printhead into its
respective color-coded socket.
8. Press in each printhead to ensure
proper contact.
9. Lift the latch forward so that the
hook catches the metal latch.
10. Push the latch towards the rear of
the printer. It should snap into place.
11. Close the print-carriage access door.
13 Printing the
printhead
alignment page
The all-in-one automatically aligns the
printheads and prints two pages.