HP Officejet 9100 Series - Page 65

Setup and Configure hp confidential 59
14 Connecting the all-
in-one to a phone
line
1. If a phone cord is plugged into the
phone jack on the wall or a phone
device, such as fax machine, unplug
the cord and set it aside.
2. On the back of the all-in-one, plug
one end of the phone cord that
comes with the all-in-one into the
line-in port.
3. Plug the other end of the phone
cord into the phone jack on the
wall or a phone device. It is
important to use the phone cord
provided with the all-in-one
because it provides the current
surge protection, such as lightning
protection to the all-in-one.
15 Connecting the all-
in-one to the
network
Connecting the network cable:Connect
the all-in-one to the network.
16a Connecting the all-
in-one to the
network (contd.)
Setting the IP address to use the e-mail
feature:
1. Press the
(MENU)
button on the
control panel.
2. Press the
(up)
and
(down)
buttons to
move to Network and I/O, and then
press the
(select)
button.
3. Press the
(up)
and
(down)
buttons to
move to Enhanced I/O, and then
press the
(select)
button.
4. Press the
(up)
and
(down)
buttons to
move to TCP/IP, and then press the
(select)
button.
5. Press the
(up)
and
(down)
buttons to
move to CFG TCP/IP=NO, and then
press the
(select)
button.
6. Move to
YES,
and then press the
(select)
button.
7. Press the
+
button on the control
panel until IP BYTE 1= appears.
8. Move to the first number in the IP
address. Press the
(select)
button to
select the number. Press the
(select)
button) again to move on to the
next number in the IP address.
Repeat until all four parts of the IP
address are configured.
9. Press the
(select)
button. The control-
panel display returns to READY state
and displays the new IP address.