60 hp
confidential Setup and Configure
16b Connecting the all-
in-one to the
network (contd.)
Configuring the e-mail settings:Ensure that
the JetDirect IP/network address is set.
1. In a supported Web browser on your
computer, type the IP address that
you assigned to the all-in-one, and
then click
Go.
2. Click the
Settings tab
.
3. In the Embedded Web server (EWS)
page that appears, click
Digital
Send
in the left pane.
4. If necessary, change the e-mail
settings. See the onscreen user's
guide for more information about e-
mail settings.
5. Use the
SMTP Server, LDAP Server,
and
Network Folder
tabs to
configure the e-mail features.
6. Verify that the all-in-
to the network server and that the
e-mail feature is working correctly.
Place an original or image on the
scanner glass.
7. Press
E-MAIL.
8. Select or type an e-mail address,
press the
Select
button, and then
press
START
.
16c Connecting the all-
in-one to the
network (contd.)
Installing the software using the starter CD:
1. Insert the Starter CD into the CD-
drive and follow the installation
procedure according to the
operating system.
2. To use the scanning features of the
all-in-one, install the Readiris
software from Starter CD 2.
3. Configure the fax features
16d Connecting the all-
in-one to the
network (contd.)
Connect the all-in-one directly to a
computer with a USB or parallel cable.
17 Registering the all-
in-one
Register the all-in-one to receive important
support and technical information.
Setup Procedure
To Next Page
Loading...