HP OMEN 27u - Support and Troubleshooting; Solving Common Issues

17
Remove DP connector
2) Lift the DP250 connector from the circuit board.
3) Place the new component on the circuit board. Be sure that it matches the footprint.
4) Solder the new component.
DC JACK connector CN102
Repair the DC JACK connector:
1) Use a hot air gun to heat the bottom side of PCB below the headphone connector.
Remove DC JACK connector
2) Lift the CN102 connector from the circuit board.
3) Place the new component on the circuit board. Be sure that it matches the footprint.
4) Solder the new component.
USB-C connector P600
Repair the USB-C connector:
1) Use a hot air gun to melt the solder on the pins.