HP Omen X Hardware Reference Guide

Accessing the tool kit
The tool kit contains the following:
●
Hard drive/power supply tool
●
Screwdriver/wrench, one side Phillips, one side hex. Hex screws are used on the graphics card and
system fans (radiators)
●
Screws
Pull the logo cover away from the case (1), and then disconnect the cable from the case (2). The tool kit is
located under the logo cover
(3).
Replacing or installing drives
The case oers four hard drive bays.
The case supports three dierent drive types:
Accessing the tool kit 9

HP Omen X Specifications

General

Operating System	Windows 10
Battery	70 Wh
Refresh Rate	144 Hz
Resolution	1920 x 1080
Processor	Intel Core i7-9750H
Graphics	NVIDIA GeForce RTX 2070