Using Windows NT 4.0
Installing Retail Windows NT 4.0
144 Corporate Evaluator’s Guide
To install touchpad/trackpoint mouse support (Synaptics)
If you have installed retail Windows you need to install the mouse driver. The driver is
contained in the \HP\DRIVERS\TOUCHPAD subdirectory on the Recovery CD.
Note
You must have NT Service Pack 2 or higher installed prior to this step.
To install or upgrade the mouse driver:
1. Run SETUP.EXE from the driver directory on your Recovery CD
(\HP\DRIVERS\TOUCHPAD).
2. Follow the onscreen directions to complete installation.
3. If you are asked for additional files, point to the driver directory on your Recovery
CD (\HP\DRIVERS\TOUCHPAD).
Upon successful completion you will be asked to reboot your computer, choose YES if
you have no other drivers to install. Otherwise, choose NO and continue to next step.
To install USR modem driver
If you have installed retail Windows you need to install the modem driver. The driver is
contained in the \HP\DRIVERS\MODEM subdirectory on the recovery CD.
To install or upgrade the USR modem driver:
1. Run SETUP.EXE from the driver directory on your recovery CD ROM
(\HP\DRIVERS\MODEM\PCIMODEM).
2. During installation you will be prompted for the communications port the modem is
on, choose COM4.
3. Follow the onscreen directions to complete installation.
To Next Page
Loading...
Need help?
General