8–2 Maintenance and Service Guide
Backup and recovery
Creating recovery discs
HP recommends that you create recovery discs to be sure that you can restore your system to its original factory
state if you experience a serious system failure or instability. Create these discs after setting up the computer for the
first time.
Handle these discs carefully and keep them in a safe place. The software allows the creation of only one set of
recovery discs.
✎
If your computer does not include an internal optical drive, you can use an optional external optical drive (select
models only) to create the recovery discs, or you can purchase recovery discs for your computer from the HP
Web site.
Note the following guidelines before creating recovery discs:
■ You will need high-quality DVD-R, double-layer DVD-R, DVD+R, double-layer DVD+R, BD-R (writable
Blu-ray), or CD-R discs. All these discs are purchased separately. DVDs and BDs have a much higher capacity
than CDs. If you use CDs, up to 20 discs may be required, whereas only a few DVDs or BDs are required.
✎
Read-write discs, such as CD-RW, DVD+/-RW, double-layer DVD+/-RW, and BD-RE rewritable Blu-ray) discs,
are not compatible with the Recovery Manager software.
■ The computer must be connected to AC power during this process.
■ Only one set of recovery discs can be created per computer.
■ Number each disc before inserting it into the optical drive.
■ If necessary, you can exit the program before you have finished creating the recovery discs. The next time you
open Recovery Manager, you will be prompted to continue the disc creation process.
To create a set of recovery discs:
1. Select Start > All Programs > Recovery Manager > Recovery Disc Creation.
Recovery Manager opens.
2. Follow the on-screen instructions.
To Next Page
Loading...
Need help?
General