Inserting or removing the battery
CAUTION: Removing a battery that is the sole power source causes loss of information. To prevent
loss of information, initiate Hibernation or shut down the computer through Windows before removing
the battery.
To insert the battery:
1. Turn the computer upside down on a flat surface.
2. Insert the battery into the battery bay (1) and rotate it downward until it is seated (2).
The battery release latch automatically locks the battery into place.
To remove the battery:
1. Close the display.
2. Turn the computer upside down on a flat surface.
3. Slide the battery release latch to release the battery (1).
4. Pivot the battery upward (2), and then remove the battery from the computer (3).
46 Chapter 5 Power management
To Next Page
Loading...
Need help?
General