To Next Page

To Previous Page

A–2 Quick Reference

Using the optical drive

Removing an optical disc (with power)

To remove an optical disc if the computer is running on

external or battery power, follow these steps:

1. Tu r n o n t h e c o m p u t e r.

2. Press the optical drive release button on the drive bezel to

release the media tray, and then pull out the tray.

3. Remove the disc from the tray by gently pressing down on

the spindle while lifting the outer edges of the disc. Hold

the disc by the edges and avoid touching the flat

surfaces.

✎

If the tray is not fully accessible, tilt the disc carefully

as you remove it.

4. Close the media tray and place the disc in a

protective case.

Removing an optical disc (without power)

To remove an optical disc if external or battery power is

unavailable, follow these steps:

1. Insert the end of a paper clip into the optical drive

release access in the front bezel of the optical drive.

2. Press in gently until the media tray is released, and then

pull out the tray.