HP Pavilion MX703/M703 Monitor Guide
35
■
Standby and Suspend modes offer low power
consumption with rapid recovery, while Sleep
mode offers the lowest power consumption
and a somewhat slower recovery.
The following table shows the characteristics
of the normal operating mode and the three
power-saving modes.
VESA Display Power Management
Signaling (DPMS)
Mode
Video
Hor.
Sync.
Vert.
Sync.
Power
Used
On Active Yes Yes ≤75 W
Standby Blank No Yes ≤15 W
Suspend Blank Yes No ≤4 W
Sleep Blank No No ≤4 W
Regulatory Information
Federal Communications
Commission (FCC) Notice
This equipment has been tested and found to comply with
the limits for a Class B digital device pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy and if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
■
Reorient or relocate the receiving antenna.
■
Increase the separation between the equipment and the
receiver.
■
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
■
Consult a dealer or an experienced radio or television
technician for help.
To Next Page
Loading...
Need help?
General