HP pavilion Series User Manual

TouchPad cable
Description Spare part number
TouchPad cable (includes double-sided adhesive) 856203-001
Before removing the TouchPad cable, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see Bottom cover on page 24), and then remove the following components:
a. Battery (see Battery on page 26)
b. WLAN module (see WLAN module on page 29)
c. Fan (see Fan on page 33)
d. System board (see System board on page 34)
Remove the TouchPad cable:
▲
Release the ZIF connector (1) to which the TouchPad cable is connected, and then disconnect
the TouchPad cable (2) from the system board.
Reverse this procedure to install the TouchPad cable.
38 Chapter 5 Removal and replacement procedures

HP pavilion Series Specifications

General

Series	Pavilion
Category	Laptop
Processor	Intel Core or AMD Ryzen
RAM	Up to 32 GB DDR4 (varies by model)
Storage	Up to 1 TB SSD
Display	14"/15.6"/17.3" FHD IPS
Graphics	Intel UHD Graphics or AMD Radeon Graphics or NVIDIA GeForce MX series (varies by model)
Operating System	Windows 10
Battery	Up to 8 hours
Ports	USB Type-A, USB Type-C, HDMI, SD card reader, headphone/mic combo
Wireless	Wi-Fi 6, Bluetooth