HP pavilion Series User Manual

Display assembly
NOTE: The display assembly is spared at the subcomponent level only. For display assembly spare part
information, see the individual removal subsections.
Before removing the display assembly, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see Bottom cover on page 24).
5. Disconnect the battery cable from the system board (see Battery on page 26).
Remove the display assembly:
1. Release the ZIF connector (1) to which the display panel cable is connected, and then disconnect
the display panel cable from the system board.
2. Disconnect the WLAN antenna cables (2) from the terminals on the WLAN module.
NOTE: The WLAN antenna cable labeled “1/MAIN” connects to the WLAN module “Main” terminal. The
WLAN antenna cable labeled “2/AUX” connects to the WLAN module “Aux” terminal.
Component replacement procedures 41

HP pavilion Series Specifications

General

Series	Pavilion
Category	Laptop
Processor	Intel Core or AMD Ryzen
RAM	Up to 32 GB DDR4 (varies by model)
Storage	Up to 1 TB SSD
Display	14"/15.6"/17.3" FHD IPS
Graphics	Intel UHD Graphics or AMD Radeon Graphics or NVIDIA GeForce MX series (varies by model)
Operating System	Windows 10
Battery	Up to 8 hours
Ports	USB Type-A, USB Type-C, HDMI, SD card reader, headphone/mic combo
Wireless	Wi-Fi 6, Bluetooth