537496-001 — Removing and Replacing the Hard Disk Drive 9
23 Remove the four screws (two on each side) that secure
the hard disk drive in the cage.
24 Slide the drive out of the cage.
Replacing the Hard Disk Drive
1 Orient the replacement hard disk drive with the label
facing up and the connectors facing outward.
2 Slide the drive into the drive cage, and align the four
screw holes in the sides of the drive with the holes in
the cage.
IMPORTANT: The new (replacement) part may not look
the same as the original part, due to different
manufacturers or models. Hewlett-Packard always
provides quality parts that meet or exceed your original
computer specifications.
To Next Page
Loading...
Need help?
General