Solid-state drive
Table 5-5 Solid-state drive description and spare part number information
Description Spare part number
256-GB, PCIe, NVMe solid-state drive L52050-001
128-GB, M.2, SATA-3, solid-state drive with TLC L52441-001
Solid-state drive shield L52441-001
Before removing the solid-state drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see Bottom cover on page 23).
5. Disconnect the battery cable from the system board (see Battery on page 25).
Remove the solid-state drive:
1. Remove the Phillips M2.0×2.2 broad head screw (1) that secures the solid-state drive to the system board.
2. Remove the solid-state drive (2) by pulling it away from the slot.
Reverse this procedure to reassemble and install the solid-state drive.
Component replacement procedures 29
To Next Page
Loading...
