Memory shield
Table 5-11 Memory shield description and spare part number information
Description Spare part number
Memory shield L52442-001
Before removing the memory shield, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the computer
on, and then shut it down through the operating system.
2. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see Bottom cover on page 23), and then remove the following components:
a. Battery (see Battery on page 25)
b. Solid-state drive (see Battery on page 25)
c. System board (see System board on page 35)
Remove the memory shield:
▲ Detach the edges of the memory shield from the retention clips built into the system board, and then
remove the memory shield.
WARNING! The memory shield is constructed of metal and has sharp edges. Exercise care when handling
the memory shield to prevent injuries.
Reverse this procedure to install a memory shield.
Component replacement procedures 39
To Next Page
Loading...
