Installing Additional Drives
When installing additional drives, follow these guidelines:
●
The primary Serial ATA (SATA) hard drive must be connected to the dark blue primary SATA
connector on the system board.
●
Connect the SATA optical drive to the white SATA connector on the system board.
●
The system does not support Parallel ATA (PATA) optical drives or PATA hard drives.
●
If needed, HP has provided extra drive retainer screws on the front of the chassis under the hard
drive cage. Hard drives use 6-32 standard screws. All other drives use M3 metric screws. The HP-
supplied M3 metric guide screws (1) are black. The HP-supplied 6-32 standard screws (2) are
silver.
Figure 16 Extra Drive Retainer Screws Location
CAUTION: To prevent loss of work and damage to the computer or drive:
If you are inserting or removing a drive, shut down the operating system properly, turn off the computer,
and unplug the power cord. Do not remove a drive while the computer is on or in standby mode.
Before handling a drive, ensure that you are discharged of static electricity. While handling a drive, avoid
touching the connector. For more information about preventing electrostatic damage, refer to Appendix
A,
Electrostatic Discharge on page 37.
Handle a drive carefully; do not drop it.
Do not use excessive force when inserting a drive.
Avoid exposing a hard drive to liquids, temperature extremes, or products that have magnetic fields
such as monitors or speakers.
If a drive must be mailed, place the drive in a bubble-pack mailer or other protective packaging and label
the package “Fragile: Handle With Care.”
Installing Additional Drives 15
To Next Page
Loading...
