b. Insert the new battery and position the clip back into place.
Figure 39 Removing a Coin Cell Battery (Type 3)
NOTE: After the battery has been replaced, use the following steps to complete this procedure.
8. Replace the computer access panel.
9. Plug in the computer and turn on power to the computer.
10. Reset the date and time, your passwords, and any special system setups using Computer Setup.
11. Lock any security devices that were disengaged when the access panel was removed.
Installing a Security Lock
The security locks displayed below and on the following pages can be used to secure the computer.
30 Hardware Upgrades
To Next Page
Loading...
