Option Description
PATA Master
PATA Slave
For each, if PATA HDD is used, allows you to:
●
run SMART self-test for selected channel:
◦
SMART Status Check
◦ SMART Short Self-Test
◦ SMART Extended Self-Test
●
auto-detect HDD size and head
●
set PATA Master/Slave device details on selected channel to:
◦ None
◦
Auto
◦
Manual
●
set access mode on selected channel to:
◦
CHS (Cylinder-Head-Sector)
◦
LBA (Logical Block Addressing)
◦
Large
◦
Auto
● view:
◦
Firmware
◦
Capacity
◦ Cylinder
◦
Head
◦
Precomp
◦ Landing Zone
◦ Sector
PATA Controller Allows you to disable/enable the PATA Controller.
Onboard FDC
Controller
Disables/enables the floppy disk controller.
Drive A (view only)
Table 3-2 Computer Setup—Main (continued)
12 Chapter 3 Computer Setup (F10) Utility
To Next Page