Display assembly
Description Spare part number
Display panel assembly, touch screen
Touch display are only spared as entire hinge-ups. Individual components are not spared.
Non-touch displays are ONLY spared at the subcomponent level. For more information about display
components, see Display components on page 20.
906973-001
This section describes removing components that require you to completely remove the display panel. For
more information about removing display components that do not require that you remove the assembly
from the computer, see Display subcomponents (bezel, webcam, panel) on page 46.
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the following components:
a. Service door (see Service doors on page 32).
b. Hard drive (see Hard drive on page 34)
c. WLAN module (see WLAN/Bluetooth combo card on page 38)
d. WWAN module (see WWAN module on page 40)
e. Keyboard (see Keyboard on page 43)
f. Top cover (see Top cover on page 50)
g. Battery (see Battery on page 62)
Remove the display assembly:
1. Position the computer upright on a at surface.
2. Disconnect the display cable from the system board (1).
3. Pull the wireless antennas through the hole in the computer (2).
4. Remove the 4 Phillips PM2.5×4.0 screws (3) from the display hinges.
Component replacement procedures 75
To Next Page
Loading...
