3. Remove the display bezel (5).
4. If it is necessary to remove or replace the display panel, remove the 4 Phillips M2.0×2.0 screws (1) that
secure the display panel to the enclosure.
5. Rotate the display panel onto the keyboard (2) to gain access to the display cable connector on the back
of the panel.
6. Lift the tape from atop the connector on the display panel (1), lift the connector latch (2), and then
disconnect the cable from the panel (3).
74 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
