Power cable
Description Spare part number
Power cable L07857-001
Before removing the power cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Place the computer in “Battery Safe mode” (Battery Safe mode on page 32).
3. Disconnect all external devices connected to the computer.
4. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
5. Remove the following components:
a. Service door (Service doors on page 33).
b. Hard drive (Hard drive on page 41)
c. Keyboard (Keyboard on page 44)
d. Top cover (Top cover on page 48)
e. Card reader board (Card reader board on page 59)
f. Battery (Battery on page 64)
g. Display assembly right hinge Display assembly – non-touch on page 73)
Remove the power cable:
1. Disconnect the cable from the system board (1).
2. Remove the power cable from the computer (2).
Reverse this procedure to install the power cable.
80 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
