2. On 15-in models:
a. Remove the two Phillips PM2.5×3.0 broadhead screws (1) that secure the palm rest to the
computer.
b. Slide the palm rest back toward the display (2), and then lift and rotate the front edge (3) to
gain access to the TouchPad cable.
– or –
On 14-in models:
a. Remove the three Phillips PM2.5×3.0 broadhead screws (1) that secure the palm rest to the
computer.
b. Slide the palm rest back toward the display (2), and then lift the front edge (3) to gain access
to the TouchPad cable.
70 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
