5. Flex the front edge of the top cover and lift up (1) until it disengages from the base enclosure,
release the top cover from the sides of the base enclosure (2), and then remove the top cover
(3).
NOTE: Steps 6 through 13 illustrate how to remove the top cover from computers with 14-in
displays. Steps 1 through 5 illustrate how to remove the top cover from computers with 15-in
displays.
6. Position the computer right-side up with the front toward you.
7. Disconnect the display panel cable (1) from the system board.
8. Remove the microphone module cable from the routing path (2), and then disconnect the cable
(3) from the system board.
9. Remove the WLAN wireless antenna cables (4) from the clips and routing channels built into the
top cover.
Component replacement procedures 85
To Next Page
Loading...
