Battery connector board
Table 5-11 Battery connector board description and part number
Description Spare part number
Battery connector board L45086-001
Before removing the battery connector board, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 32).
2. Place the computer in Battery Safe mode (Battery Safe mode on page 32).
3. Remove the bottom cover (Bottom cover on page 33).
4. Remove the battery (Battery on page 34).
Remove the battery connector board:
1. Remove the two Phillips M2.0 × 2.5 screws (1) that secure the board to the computer.
2. Rotate the board upward (2), and then remove the battery connector board from the computer (3).
Reverse this procedure to install the battery connector board.
48 Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
