4. Lift the back of the board up, and then remove board from computer (4).
Reverse this procedure to install the USB board.
Fingerprint reader board
To remove the ngerprint reader board, use this procedure and illustration.
Table
6-8 Fingerprint reader board description and part number
Description Spare part number
Fingerprint reader board M03434-001
Fingerprint reader board cable (included in Cable Kit) M30646-001
Fingerprint reader board bracket M30665-001
Before removing the ngerprint reader board, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 31).
2. Remove the bottom cover (Bottom cover on page 31).
3. Remove the battery (see Battery on page 38).
Remove the ngerprint reader board:
1. Remove the Phillips M2.0 × 2.0 screw (1) that secures the ngerprint reader bracket to the computer,
and then remove the bracket (2).
2. Disconnect the cable from the ZIF connector on the ngerprint reader board (3).
46 Chapter 6 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
