m. Open the display and remove rubber spacer strips.
n. Replace the hinge cover by positioning the cover over the bottom of the display, rotating the cover
upward, sliding it to the left, and then replacing the screw.
9. If you need to remove the hinge cover from the display enclosure:
a. Remove the Phillips M1.2 × 3.0 screw (1) that secures the hinge cover to the display.
b. Slide the hinge cover toward the right (2).
c. Rotate the bottom of the hinge cover up, and then remove it from the display (3).
d. Note the location of all cables hidden by the hinge cover so that you can be sure to properly route
the cables during reassembly.
The hinge cover is available in the Plastics Kit as spare part number M30663-001.
10. If you need to remove the hinges from the display enclosure:
a. Remove the three Phillips M2.5 × 10.0 screws (1) from each hinge.
b. Remove the hinges from the display (2).
The hinges are available in the Hinge Kit as spare part number M30666-001.
Component replacement procedures 61
To Next Page
Loading...
