c. Disconnect the smaller cables from the reverse ZIF connectors on the hub board (3) (4).
d. Use a tool (5) to release the board from the display rear cover (6).
The hub board is available as spare part number M30673-001 in models with an IR camera and
M30672-001 in models with an RGB camera or microphone module.
13. If you need to remove the ambient light sensor from the display, disconnect the cable from the reverse
ZIF connector on the board (1), and then use a tool (2) to release the sensor from the computer (3).
The ambient light sensor is available as spare part number M30669-001.
Component replacement procedures 63
To Next Page
Loading...
