18.
If it is necessary to remove the WWAN antenna transceivers (1) and cables, remove them from
the display enclosure back cover by lifting them (2) from the clips in the display enclosure back
cover.
19.
If it is necessary to remove the WLAN antenna transceivers (1) and cables, remove them from the
display enclosure back cover by lifting them (2) from the clips in the display enclosure back cover.
20. If it is necessary to replace the display panel hinges, remove the six Phillips PM2.0×3.0 screws
(1) that secure the display panel hinges to the display panel, three screws on the left and three
screws on the right.
Component replacement procedures
95
Downloaded from LpManual.com Manuals
To Next Page
Loading...
