!!PWRxFish-Final01.book Page 12 Tuesday, October 7, 2003 1:58 PM
Planning and Implementing a PoE Configuration
For example, if you wanted to view the PoE status of port 5 on a Switch 2626-
PWR or Switch 2650-PWR, you would use show power-management 5 to display
the data:
Figure 3. Example of Show Power-Management < port-list > Output
Planning and Implementing a PoE
Configuration
This section provides an overview of some considerations for planning a PoE
application. For additional information on this topic, refer to the HP ProCurve
Switch 2600-PWR Series Planning and Implementation Guide.
Assigning PoE Ports to VLANs
If your network includes VLANs, you may want to assign various PoE-config-
ured ports to specific VLANs. For example, if you are using PoE telephones
in your network, you may want to assign ports used for telephone access to a
VLAN reserved for telephone traffic.
Applying Security Features to PoE Configurations
You can utilize security features built into the switch to control device or user
access to the network through PoE ports in the same way as non-PoE ports.
12
To Next Page
Loading...
Need help?
General